Skip to end of metadata
Go to start of metadata

Aug 13, 2022 01:15

W-PA Recovery Procedure

The Document describes how to perform W-PA recovery procedure.

W-PA Documentation: W-PA SIP Public Announcer - Admin Manual.

Created: March 2019


To perform W-PA recovery procedure, proceed with the following steps:

Access Post Mode Process

Note: Please set the FTP server correctly and configure your PC IP  at range of 192.168.10.* before proceeding with the following steps.

  • Connect W-PA via cable to LAN port of W-PA
  • Power the gateway off. Then you can use Telnet
  • On your PC, please use telnet

Configure page as below:

Post Mode Clear Configuration

  • Input "3 Clear Configuration" and enter for clear configuration:

Update Firmware in Post Mode

Note: Please set the FTP server correctly before performing the following step.

  • Input "2 FTP Update Image" to update firmware:

The server address is the IP of your PC.

The image name is the name of the firmware you place in FTP server directly.

The device provides safe mode. When there is booting issue because of setting firmware, user can restore the factory setting or upgrade to a new firmware to solve the issue.

Save and Reboot your W-PA

  • Input "4 Exit and Reboot" to restart the device:

Access to W-PA

Consult W-PA SIP Public Announcer Manual to access and configure the device.

Not finding the help you need?
Join the Facebook group to ask a question!