Topic Title

Hi,

Does someone have Experience to configure one Port of a Bri04 for one ISDN Device with an Extension Number?

Thanks!

Best Regards,
Thomas

[matteo.erba]

Hello Thomas,
is your need to connect an ISDN phone to our gateway?
We currently don't supports users through ISDN by provisioning, the gateways are normally used to connect external lines or legacy PBXs. But we often the mobility extension to contact phones on legacy PBX and offer to the user some UC&C services even with old phones

Hi Matteo,

No i need to connect a seperate Fax Server (Spexbox).
I need two faxserver the Wildix Faxserver and a seperate Faxserver (Spexbox) which needs an internal ISDN Line.

Thanks!

[fabrizio.dichello@wildix.com]

Hi Thomas,

it's very easy to config an "S0-Bus" for ISDN modem / fax devices.

First of all, setup a BRI port as "internal"-Bus (example port 2):

BRI config S0.png (77.54 KiB) Viewed 6560 times

Then, for incoming calls, assign a number as "MSN" number (i.e. DID 959595 assigned to MSN 47):

S0 MSN dialplan.png (18.92 KiB) Viewed 6560 times

If you need also to dial out from internal ISDN modem / fax, config and assign to internal ISDN port this dialplan:

Dialplan S0.png (45.23 KiB) Viewed 6560 times

Note: "Einstellen ITC unrestricted" rule only needed for data calls (modem).

Enjoy!